|
|
- Up to 30 transmitters can be assigned into four groups and registered. Needless to say, all 30 units can be registered into one channel.
- To register a transmitter, simply set the receiver to "Registration mode" and operate the transmitter to send the radio wave signal.
- The alarm volume can adjusted according to the location, using the volume dial on the side of the receiver, from 0 to 75dB.
- Receives the battery exhaustion signal from each transmitter, and notifies of the battery exhaustion state with blinking of the operation indicator and an intermittent chime corresponding with the reception channel.
- Both AC/DC power supply terminals can be used according to the location. Ready to use by simply inserting the 2m long AC cord equipped from the factory into an outlet.
- When receiving the radio wave signal from a transmitter, the operation indicator will blink, the dry contact will be output, and the chime corresponding with the reception channel will ring.
Chime sound |
Contact output |
Channel 1: Ding-dong
Channel 2: beep-beep beep
Channel 3: Ring-ring
Channel 4: Pororon |
Alarm output (General): Dry relay contact SPDT
30V AC/DC, 0.5A
One shot operation |
| Model No. |
RX-200A-S |
| Voltage |
100V AC 50/60Hz or 10 to 16V DC |
| Power/ Current consumption |
5W or 280mA max. |
| Operating frequency band |
426MHz band
(wireless equipment of low power security system) |
| Coverage distance |
Approx. 100m (line-of-sight distance) |
| Antenna |
λ/4 whip antenna |
| Contact output |
Contact type: General dry relay contact (N.O.N.C)
Contact rating: 30V AC/DC, 0.5A (resistive load)
Contact operation: One-shot operation for reception of CH1 to CH4 (approx. 4 seconds) |
| Alarm Sound |
CH1: Ding dong
CH2: Beep beep-beep beep
CH3: Ring-ring
CH4: Pororon
Sound duration: Approx. 6 sec
Sound volume: 0 to 75db/1m ahead
Changeable using the sound volume
Battery exhaustion alarm: Chime rings intermittently. |
| Indicator |
2-color LED (red and green)
Power ON: Green light ON
Battery exhaustion alarm: Green light blinks
Reception of CH1 to CH4: Red light ON (synchronized to alarm output)
Lack of reception sensitivity: Red light blinks (synchronized to alarm output)
Registration mode: Red and green lights ON alternately. |
| Operation switch |
Power switch
Registration channel selector (internal)
Cancellation switch (internal) |
| Allowable number of registered transmitter |
30 units |
| Wiring |
Terminals
(AC power supply input: Plug and terminal types combined) |
| Mounting position |
Indoor (wall mount type) |
| Ambient temperature range |
-10°C to +50°C |
| Weight |
Approx. 650g |
| Appearance |
ABS resin (white) |
|
